Post by whywhy250tea on Jun 4, 2019 19:19:19 GMT -6
Hey you all, so I recently bought my Jonway YY250t and I love it! However, I was moving it with the motor off, then it started to tip, I caught it. But, I grabbed it by the right handle bar switches throttle assembly and basically broke it I can completely rotate the entire housing and slide it and the throttle across the handlebars like a sad slide whistle.I know I need to get the right handlebar switches/wires replacement and prob a new throttle. But I can't seem to figure out how to (excuse the noobness) remove the plastics beneath the dashboard to access where the cables are going to figure out if I need a 5 or 9 pin assembly. Any help or insight is GREATLY appreciated. Riding the bus until I get this fixed. Thanks in advance!
