Clinician
Currently Offline
Posts: 11 
Likes: 0
Joined: Jun 6, 2016 15:01:36 GMT -6
|
Post by harry on Jun 25, 2016 19:58:57 GMT -6
Float stuck in the closed position ( up),, so no fuel getting to the carb,,, it's obviously a fuel issue now that you got it to pop with ether That is what I am thinking. The jet, needle and everything is clean and clear, but I am concerned that I could not hear the float rattle when I shook it after reassembly. Seems like I should be able to hear it move. Before, it may have been partially open allowing the bowl to fill after an hour - so it would start and run great for 30-40 seconds and not restart. Guess I will have to try a 3rd r&r. A big problem is that the drain port was never drilled out in the casting so I can't open and test it. Think I might do that this time. |
|
|
|
Post by cyborg on Jun 25, 2016 21:29:38 GMT -6
I hate that crap,,,drill it and tap put a screw,,,this is silly now you should be riding,,,it's got to be the bowl not filling
|
|
Doc's Anything Goes
Currently Offline
Posts: 2,739
Likes: 66
Joined: Oct 23, 2010 19:29:21 GMT -6
|
Post by tvnacman on Jun 26, 2016 4:48:48 GMT -6
|
|
Clinician
Currently Offline
Posts: 11
Likes: 0
Joined: Jun 6, 2016 15:01:36 GMT -6
|
Post by harry on Jun 26, 2016 20:12:22 GMT -6
I hate that crap,,,drill it and tap put a screw,,,this is silly now you should be riding,,,it's got to be the bowl not filling THANKS CYBORG! Runs great again! Did you know the float could be put in upside down?  |
|
|
|
Post by cyborg on Jun 26, 2016 20:49:33 GMT -6
Go get a small ball pein hammer and hit yourself in the head 3 times saying stupid stupid stupid!!!!! Then when you wake up say 4380 Hail Marys and 9765 Our Fathers for this transgression,,,,,lol glad you sorted it out,,,,,,,there's a piston right there!!!!!
|
|
