all turn signals don't work By mylloyd (Read 1,923 times)

[mylloyd]

all turn signals don't work on my shanghai shenke 150cc . they did but stopped. how do i fix them.....

[Bashan]

Usually when all of the signals quit working it's the flasher. You'll probably find it under the upper front cowling. It should make a clicking noise when you activate a turn signal. Here's a PDF on turn signal trouble shooting.

[mylloyd]

Ty again Bashan.........

[rob63]

Nov 29, 2012 10:24:15 GMT -6 mylloyd said:

Ty again Bashan.........

What exactly did you get round to checking ?
Working backwards....take off whatever plastics it takes to get to the back of the indicator switch (by left grip).
Unplug the multiplug which goes into the switch, there should be 3 wires. Get a long piece of wire, remove the insulation from each end of about 1cm. Connect one end to the battery + terminal, with the ignition on place the other end of the wire in each of the multiplug terminals in turn. In 2 of the wires it should light up either the left or right bank of indicators.
The remaining wire will be the feed from the flasher unit, using a multimeter check to see if you are getting voltage on that wire. Follow it and tell us how many wires the flasher unit has going into it.

[Alleyoop]

We are trying to HELP Do NOT understand your your remark "TY AGAIN BASHAN"!!!

What did you check or did not check?
Very simple to test, get your volt meter or light tester whichever you have put the turn signal on and check the wires connecting to the flasher. One is usually ground and one is voltage. If no voltage then the problem is by your switch. If voltage is at the flasher then its your flasher pretty simple dimple.

Some Flashers are 2 wires and some 3 and you can get them at any auto parts store just make sure it is 12v and the same number of wires as yours 2 or 3 .
Alleyoop