Clinician
Currently Offline
Posts: 8
Likes: 0
Joined: Dec 17, 2022 21:40:56 GMT -6
|
50cc gy6..
by: doublec - Dec 17, 2022 22:02:49 GMT -6
via mobile
Post by doublec on Dec 17, 2022 22:02:49 GMT -6
I just brought a 50cc trike. It had small issue. So I thought. After it warmed up at full throttle it would bog out. I would run it about half for a minute then be able to open it back up.. so I did a carb clean. Still doing it until one day I got stuck. No spark nothing. So I just replaced stator, ignition coil, starter relay, cdi and rectifier. Got it started. Went to take for a ride. Ran good. Then stated doing something at full throttle. It kept losing power till it died. Tried to restart battery was dead and the spark plug was melted at the top where it sparks. I'm lost. Was hoping to get some feed back before I mess with wire harness. Any help would be appreciated...Thank you.
|
|
|
|
50cc gy6..
by: kz1000st - Dec 23, 2022 19:04:18 GMT -6
Post by kz1000st on Dec 23, 2022 19:04:18 GMT -6
First I would look for a cracked intake manifold or a cracked or broken vacuum line. Melting a spark plugs requires a really hot situation indicitive of a massive lean condition.
|
|
Clinician
Currently Offline
Posts: 8
Likes: 0
Joined: Dec 17, 2022 21:40:56 GMT -6
|
50cc gy6..
by: doublec - Dec 26, 2022 13:50:56 GMT -6
via mobile
Post by doublec on Dec 26, 2022 13:50:56 GMT -6
Ok will check that first..
could it be adjustment on carb ?
|
|
Clinician
Currently Offline
Posts: 8
Likes: 0
Joined: Dec 17, 2022 21:40:56 GMT -6
|
50cc gy6..
by: doublec - Dec 27, 2022 0:15:35 GMT -6
via mobile
Post by doublec on Dec 27, 2022 0:15:35 GMT -6
Wires are very brittle. When I move something the insulation on wires crack which I'm sure isn't good. I ordered a new wire harness and a intake manifold. Want to build this scooter. Should of asked before but will I need to up grade any wiring for 8 pole stator besides rectifier and
|
|
