Looking for lower swing arm bushings By scooteraddict (Read 939 times)

[scooteraddict]

First I would like to say that I love these forums. Great information and all.

Now. I'm in a bind and need expert help.

Well after riding one day on a wavy road one day, I noticed that the rear end was wobbly. I pulled over thinking that my tire was going flat but it was fine. After further investigation, i found that the bushings on the lower haft of the swing arm were worn.

Now I have been searching for a while and can't find the bushings that I need.

What I need is a bushing that is 25mm OD x 10mm ID x 30mm w however the exact center is actual 72mm long.

I'm at a lost and really would like to get the bike up and running again before I go on vacation in two weeks.

Anyone might know where to purchase one?

[ce]

Roketa.com, they got yer bushing for three dollars.

Search roketa parts and go to the one for atv and fitness, open the scooter section and it should come up on the 54B, look in the engine section.

[scooteraddict]

Far from it. First the swing arm does not come with bushings and they don't have any bushings pictured or listed.

Here is a drawing of what I'm looking for.


It goes into the lower section of this swing arm.


As you can see this bushing has a longer end so that when two are inserted in opposite directions, they would make a long tube within the center.

[sunlproblems]

they sell the whole swing arm all chinese scooters .com

[Bashan]

Apparently there are no parts available for what you need. I ran a couple searches and there were a lot of complaints from other folks in that regard. I think I did find the site sunlproblems was referring to and they did have a boatload of swing arms right here. I couldn't narrow the search any further on that site so you might wade through what they have and see if anything is applicable, but from what I read it will probably be fruitless. You may need to faabricate something or have it made. Sorry, Rich