Scooter Doc
Currently Offline
Posts: 330
Likes: 1
Joined: Nov 2, 2011 14:28:14 GMT -6
|
Post by Gti on Feb 7, 2012 16:26:13 GMT -6
Who sells them and how much are they? This is the last piece of this flippin' puzzle!!!
|
|
|
|
Post by Alleyoop on Feb 7, 2012 16:39:44 GMT -6
You need TWO special tools one is the Flywheel Puller the other is the Starter Clutch NUT after that is just your regular metric sockets.
Try some of the advetiseing dealers on top of the forum.
Alleyoop
|
|
|
|
Post by Bashan on Feb 7, 2012 20:46:21 GMT -6
Alley's right, you've got to have the right tool for the flywheel or you'll ruin the threads. Mike at Buggy Parts NW sells very nice ones. Here's a picture of one you can click on for more information:
Now, the tough part is finding a tool that will pull the gear off of the other side of the crankshaft. It's hard to get anything under the gear without ruining the shaft or the case. Many folks have built their own tool or used one of these from Harbor Freight. Some have used a large screwdriver and hammer but the results are often brutal. Good luck, you'll need it. Rich
|
|
|
|
Post by Alleyoop on Feb 7, 2012 21:10:51 GMT -6
Here is the Spanner Tool to take the Nut off to get the Starter Clutch off: Alleyoop  |
|
..BAD TO THE BONE..
