Slider Guides problem By epdowd (Read 570 times)

[epdowd]

I thought I had a DR. Pulley Variator and I needed 3 Guides, ordered them from BPNW. They are too small so with a conversation with BPNW the small size goes with the DR. Pulley.. The large guides I need are :
15mm front to back
8mm high
8mm groove that slides on the plate
the Variator plate diameter itself is 120mm
Does anyone know where I can get the guides I need ?. I'm sure they are out there, I just haven't had any luck yet.
Thanks and I hope the pictures are OK.

[Alleyoop]

From what you are saying you have a 123mm Variator am I correct? Is your motor a ZN150T-18 Motofino as what is in your sig? If so that CVT in your scoot is actually what usually comes with the 250cc scoots.
Alleyoop

www.ebay.com/itm/like/301400584295?lpid=82&chn=ps

[epdowd]

Thanks for your reply Alley. Yes it is a 150T-18 Znen, 16 inch Wheels, 123mm Variator. I guess I should start looking in the 250cc parts.. Yep, I'm confused

[epdowd]

OK, Mystery solved !!. Due to my one brain cell that is still partly active, I found out by going back to 2010 on this forum that I have the OEM Variator on my scoot. All the Znen 150T-18 models came with the 123mm OD Variator. Like Alley said they are 250cc Variators. That is why I couldn't find the correct size slider guides. I'm not promoting any seller but the guides are available from ebay as Alley said and also scooterparts4less alias Moxie scooter parts... Hope this helps some of the other Znen'ers with 16" wheels.
Thanks for the help Alley

[epdowd]

Ok,,I finally found the correct slider guides from Extreme Scooters, Very helpful people !!
The correct slides are for the GY6B 150cc engine with the 123mm diam. Variator... They are 130mm wide at the vertical portion of the guide vs. 147mm for the 250cc engine. So now I can get my scoot doing what it is supposed to do,, Thank you all for the help !!!

[cyborg]

Nice!!