Just a TIP: To secure water boots to the back of headlights By olivertwisted (Read 391 times)

[olivertwisted]

I toiled with using silicon on the inside lip, it slipped too much to secure anything around the outside lip. I tried using steel wire alone, around the outside lip, they would pop off. Zip ties around the lip after getting the cups around the hard lip of the molded plastic worked . Around here, salty moisture is our worst enemy. That fact is well understood by those whom saw my scoot when I first obtained it !

[Alleyoop]

Good job, as they say where there is a will there is a way

[olivertwisted]

Absolutely!

[richardv]

Thanks for the info. I live very near two large bodies of water but they aren't salty. Just supply a lot of Lake Effect Snow.