new stator dead out of box By lostforawhile (Read 555 times)

[lostforawhile]

Ok I replaced my stator , I had charge coil voltage too low for the CDI, I had an 8 pole, dual charge coil 5 wire, the fifth wire is really irrelevant as it just grounds to the stator frame, and is just an extra ground, I can now start the scooter, but I have no AC voltage on either output wire, I had AC voltage before. I have a good ground wire from the battery all the way to the stator case. I can measure 60 ohms on each wire to ground. This is a single charge coil with two yellow wires, instead of a yellow and white, but both should be the same, it's just AC voltage from each winding, one goes to each side of the regulator rectifier, but I'm measuring 0 volts ac to ground to each wire right out of the stator case, I haven't pulled the flywheel again to check for pinched wires, but my meter is telling me they aren't anyway. any ideas? some kind of oddball wired stator?

[cyborg]

Most likely a dud,,,had quite a few parts be doa right out of the box,,,even car parts,,,maddening

[czmdiver]

Man that sucks
Im glad Danmartin at Martinmopeds educated me/us on the supplying real quality Scooter Electrical components, I won't buy Scoot electric from anyone else.

[lostforawhile]

from what I understand the 5 wire with two yellow wires is wired differently then the 5 wire with one yellow and one white wire, despite what they advertise, I'll probably end upgrading to an 11 pole and 6 wire regulator 

[kevmerica]

I have to keep recharging my batteries… Is this an indicator of a bad stator?

[cyborg]

Or the regulator is bad

[lostforawhile]

they were bad at the stator itself, and the new one went ten miles before the charge coil started failing