Clinician
Currently Offline
Scoot over, and he means it!
Posts: 23
Likes: 0
Joined: Aug 5, 2011 9:03:24 GMT -6
|
Post by scootover on Aug 23, 2011 11:12:54 GMT -6
Ok, I got a problem here and I need some help fast! I have drained the oil on my 2009 Ice Bear 150cc trike, and cant find where to put the gear lube back in at! There is no fill port I can find at all.
Do I just take the vent hose off and fill it from there, and if so, how much gear lube goes in there? I dont want to over fill it and have gear lube shooting back out that vent hose.
Scootover...................needs help on this one!
|
|
|
|
Post by Alleyoop on Aug 23, 2011 12:30:48 GMT -6
HAHAHA!! Yea the Fill Screw is Actually BEHIND the SPROCKET and if you want to fill it through there you have to take the Sprocket off. But no need to do that use the VENT hose to fill it up. Put in 8oz of gear oil. And tie the Vent hose up on the frame. Alleyoop What I did is get a bigger hose and put the Vent hose inside it and ran the Bigger hose over the frame and tied it to the Bracket that holds the Axle pointing down. Did the same thing with the Valve Cover Vent hose. That way if any oil squirts out of either the Valve Cover Vent or Tranny Vent no oil gets on my motor. Alleyoop  |
|
Clinician
Currently Offline
Scoot over, and he means it!
Posts: 23
Likes: 0
Joined: Aug 5, 2011 9:03:24 GMT -6
|
Post by scootover on Aug 23, 2011 13:12:39 GMT -6
Alley..............Your a life saver! I found the fill plug behind the sprocket. I did take it out, got out my cajun injector syringe, shortended it bit, and squirted the lube oil right it. I took it out just so i had a vent.
Was done in 10 minutes.
Your a smart one! Thanks again for your help.
Scootover
|
|
..BAD TO THE BONE..