Wire that plugs up to ignition coil broken By jjoshua20213 (Read 410 times)

[jjoshua20213]

Ok so you know how the coil plugs up to the spark plug, and on the other end are two pins you plug two other wires too. Well those wires look SUPER cheap and thin to be carrying electricity. And when upgrading the coil one even broke, so i'm using tape to hold it in place. The bike misfires at high RPM like it wants to go faster but cant. Sometimes it gets loose while riding and the engine drops to like 15mph from 35. I pull over fix it, then go about my bussiness.


On the other hand What is this wire call so I can replace it?

I installed a 50mm bbk still the same speed if not slower, but slightly better acceleration. Any ideas?

[tvnacman]

up gear , to fix the wire you will need get another end and crimp it on .
snap a picture and post it so we can see what it is .

John

[jjoshua20213]

What all would "up gearing" entitle? Around how much would I have to throw into this money pit? I fixed it with a soldering iron. But otherwise I think your idea is the only way. I would take a pic but i'm too lazy and already fixed it. But thank you.

[Alleyoop]

all you have to do is go to the hardware store and get female plugs crimp it on the wire and plug it onto the male plug on the coil. But if you fixed it ride on.
Alleyoop