1P57QMJ 150cc Rear Disc Brake Engine.. By shop242 (Read 404 times)

[shop242]

Can Anybody find one? I Had to convert a drum brake set-up.. was a biatch!

[tvnacman]

can you post a picture .

John

[Alleyoop]

Motors with disc break setup are hard to find,
But since you converted yours to Drum how about telling the folks how and with some pictures for others that may have to do the same because they cannot find a motor with disc break setup.
Alleyoop

Here is one From MBE.

[tvnacman]

if the caliper and rotor mount on the swing arm side , you can use the drum motor .

John

[shop242]

I converted the drum engine to disc,,The rear caliper mounts on the swing-arm .. Had to do some serous grinding around axle shaft esp around the brake pin.. Had to grind the brake pin off as well, Too late to post a pic ( my bad )..But it can be done with a side grinder. Also, I have 12 inch wheels that threw a curve into the project

[shop242]

Hey John ! I called U a while back about the drum to disc conversion..Another thing I found , Less grinding would have occurred if I had 13 inch rims or bigger. Also had to cut the round lip off the edge of the brake drum houseing

[tvnacman]

here is a picture before


this one was in the more active roll to get the parts (brake caliper mounts)



let me see if I have a pic of it completed .

John

[tvnacman]

Nov 11, 2013 16:01:22 GMT -6 shop242 said:

Hey John ! I called U a while back about the drum to disc conversion..Another thing I found , Less grinding would have occurred if I had 13 inch rims or bigger. Also had to cut the round lip off the edge of the brake drum houseing

Shop I get several calls a day , I hope it was helpful .

John