Senior Clinician
Currently Offline
Posts: 185
Likes: 5
Joined: Sept 7, 2013 7:25:20 GMT -6
|
Post by clonedrone on Feb 19, 2014 20:14:39 GMT -6
I have my trike setup to not run high rpms. It will run 50mph at 5100-5200 rpms(just about half throttle) at 60mph 6100-6200 rpms at 70mph it runs little over 7K so it runs 10mph faster for every 10K rpms. The trike came with 13 front and 10 rear wheels I have put changed out the rear TIRES to 3" taller ones. So my Trike cruises at very low RPMS once I get it up to speed then I back off the throttle and it stays at the speed i brought it up to. Alleyoop Good Stuff! Thanks! I'm in the midst of a 61mm BB and a 2mm stroker, and looking for this type of gearing to start with. |
|
|
|
Post by Alleyoop on Feb 19, 2014 21:12:43 GMT -6
Yea the 16/37 gearing will do you well with the 61 and 60mm stroker.
Alleyoop
|
|
Certified Clinician
Currently Offline
Posts: 58
Likes: 0
Joined: Oct 13, 2013 6:36:10 GMT -6
|
Post by oldscootcoot on Feb 20, 2014 10:10:13 GMT -6
I ordered a 15/37 gear set for a 2.46 final. I'm already two tire sizes larger than was stock so figure this is a good set to relax the cruise a bit and still have fairly good bottom end left. The 842 belt worked perfectly, finally reaching the entire diameter of the vari. Also allowed the rear sheave to close more giving a noticeable lower ratio on take off.
|
|
..BAD TO THE BONE..
