Clinician
Currently Offline
Posts: 5
Likes: 0
Joined: Mar 20, 2018 11:22:55 GMT -6
|
Post by beast on Aug 19, 2018 13:12:29 GMT -6
 heres a pic of it |
|
Clinician
Currently Offline
Posts: 5
Likes: 0
Joined: Mar 20, 2018 11:22:55 GMT -6
|
Post by beast on Aug 19, 2018 13:09:45 GMT -6
picked one up a couple years ago, it was pretty rough. have rebuilt or made body parts, it looks pretty good. got it running, ran great, but after every 20 miles i had to charge the battery. stator output was less than 5 volts. got a new stator and installed it. tried to fir it up...no spark. changed CDI and rectifier. stll no spark. checked all my wiring over carefully. cant find anything wrong. got looking, no juice coming from CDI to coil. after a week of digging i found new stator has no ground wire. could this be why its not working right? voltages from stator arent very high either, 26-60 at best
am considring putting a ground wire on stator. should i?
|
|
Clinician
Currently Offline
Posts: 5
Likes: 0
Joined: Mar 20, 2018 11:22:55 GMT -6
|
Post by beast on May 3, 2018 6:39:20 GMT -6
got the schematic, it was a whole lotta rough, so i took the time and redid it coup[le minor differences, it shows 2 turn indicator lights on panel, my unit only has one and some of the wire colors arent the same. who hasnt run into that before...lol  |
|
Clinician
Currently Offline
Posts: 5
Likes: 0
Joined: Mar 20, 2018 11:22:55 GMT -6
|
Post by beast on Apr 23, 2018 8:49:30 GMT -6
|
|
Clinician
Currently Offline
Posts: 5
Likes: 0
Joined: Mar 20, 2018 11:22:55 GMT -6
|
Post by beast on Mar 20, 2018 11:26:38 GMT -6
it was working great, battery went dead, recharged and now wont engage starter
looked inside, lots of spliced wires, need diagram so i can figure out and repair or replace wiring
thank you
|
|
