m7 thread By masterburt (Read 505 times)

[masterburt]

Hi guys i seem to keep breaking my cylinder head stud set the lengh is 110mm with the m7 thred,is there a alternative ie, strong steel or something that won't break,i am thinking that it's the cheap quality stud set i keep buying and can't find an alternative, i could perhaps ask a local engineering company to make me some but i dont know what to ask for 

[Bashan]

What bolts are you talking about MB? The dowels? They're a lot longer than that.

[cyborg]

ARP make the best studs and bolts on the planet

[Alleyoop]

110mm you must be talking about the Valve cover bolts(about 4 inchs long). If you keep breaking them you are tighten them to much, It is not bolts fault. The valve cover bolts are only supposed to be tighten to a SNUG fit, the valve cover has a O-Ring gaskets going all around the valve cover.

[masterburt]

www.pedparts.co.uk/product/1806/cylinder-studs-and-nuts-set--piaggio-50cc

these ^^^^ I'm sure the compant i'm buying them off have a crap quality, need something like hardend steel or something that they won't thread ect

[Bashan]

Gee Burt, I'm not sure where these go:

Hey, what's the funny sign in front of the cost? That's one of them thar Brit things! Let me check your IP....Stoke-on-Trent!? is that!?? You're from the other side of the pond!!! And those parts are for a two cycle!!

Apparently Cyborg isn't full of it for once. Call these people and tell them what you want. Cheerios...ta ta...and bullox the Stoker...or whatever you people say.