Clinician
Currently Offline
Posts: 11 
Likes: 0
Joined: Aug 22, 2014 10:21:36 GMT -6
|
Post by kttb on Aug 31, 2014 10:38:16 GMT -6
so i just bought a jinlun jl250p , and when it starts up (in neutral) the rpm goes up to 4000k , what should i do?, adjust the idle screw? if yes can someone tell me where it is ( i know it in the card but what side) , thank you
|
|
Doc's Anything Goes
Currently Offline
Say no to scooter abuse
Posts: 3,873
Likes: 156
Joined: Mar 31, 2010 19:07:16 GMT -6
|
Post by jct842 on Aug 31, 2014 11:49:18 GMT -6
Follow the throttle cable down to the carb. Adjust the throttle stop. That is more than the mix adjust will do.
|
|
|
|
Post by Alleyoop on Aug 31, 2014 12:46:37 GMT -6
|
|
Clinician
Currently Offline
Posts: 11
Likes: 0
Joined: Aug 22, 2014 10:21:36 GMT -6
|
Post by kttb on Aug 31, 2014 13:17:33 GMT -6
Follow the throttle cable down to the carb. Adjust the throttle stop. That is more than the mix adjust will do. Is there a tutorial on how to do this? Thank you so much |
|
Clinician
Currently Offline
Posts: 11
Likes: 0
Joined: Aug 22, 2014 10:21:36 GMT -6
|
Post by kttb on Aug 31, 2014 13:19:49 GMT -6
Is this one the idle screw?  |
|
|
|
Post by Bashan on Aug 31, 2014 15:31:52 GMT -6
That pic looks like a flatside carb and I don't think that's the idle screw. Your bike is not a scooter and you should seek out a forum specific to your machine in my opinion. Rich
|
|
|
|
Post by Alleyoop on Aug 31, 2014 19:52:41 GMT -6
Yes, that screw you circled turn it COUNTER CLOCKWISE to lower the idle, that is a flat side carb which has the throttle cable going into the top of the carb and it hooks on to the slider with the needle. Alleyoop  |
|
..BAD TO THE BONE..
