Strada Scooter RX-200 Oil Seal By hiskid1973 (Read 375 times)

[hiskid1973]

The belt broke last summer and one of the steel wires got in back and wrapped around the oil
seal and pushed it in the engine. I got the correct seal from two different places to make
sure the size was correct.. It seems the seal goes in place but with in very short time after
starting the seal just pops out and oil starts leaking. It is the correct seal. My thought is
the wire spinning around in the seat wore the space open a bit more. I put non hardening
gasket sealer around but it didn't help. I thought about epoxying a thin wire across the seat
above and below the shaft. Any other ideas. There was no issues till the belt broke and the
wire went back there. Another thought, there is a gap between the pressed on gear and the seal.
What if I put another seal facing it with the two front sides together holding it in place.
Thanks for any thoughts or ideas. GBY

[cyborg]

can you post a pic of the shaft and engine boss that the seal gets pressed into please?

[Alleyoop]

As for the Seal Get a Honda Seal they are a little bit bigger and will fit tighter.

[hiskid1973]

The scoots in the shed and it would be hard to get a picture. Can you give an
ebay link to the Honda seal. Thanks

[Alleyoop]

Sure give me a minute to locate it on my computer.

Found it.
www.partzilla.com/parts/detail/honda/HP-91201-KCW-880.html