Throttle/mirror holder moves By jjoshua20213 (Read 425 times)

[jjoshua20213]

Ita a tao tao cy50-a

The bike went down a couple times, but I took the current part from another identical bike to replace the old one witch had the same problem.

Is won't tighten, as if the circumference of the handle bar is smaller than the grip.

It would easily slid off the handle bar if wires weren't attached


Any suggestions/reasons to this problem?

I know i'm assembling it right because i've taken it off before to replace the cable with no problems

[jerryscript]

Could be different diameter handle bars. Regardless, all you need to do is shim it. You can cut a piece of a can, or use a strip of rubber, you probably won't need to fully wrap it, just enough to get it tight.

[jjoshua20213]

Thanks