Certified Clinician
Currently Offline
Posts: 67
Likes: 0
Joined: Oct 9, 2013 20:52:00 GMT -6
|
Post by robertban on Oct 14, 2015 22:22:20 GMT -6
Here are some picture of my 2013 Jonway or the (MC-13-250) chinese scooter that I had done off and on this summer (Yep it sure looked funny riding around wires hanging and tied up all over “what the hell it’s my scooter”) like I said this was done threw out the summer so I done the voltage readings that I could remember (could be wrong on some)also moving the CDI, Blocking Diode, and R/R all to the front of the scooter for better air flow and easy to get to also I added an electric fuel pump and rigging up the vacuum pump for easy hookup if I should need it I also replaced the radiator fan with an higher output one and an R/R (VRRPM3H) from Oregon Motorcycle Parts don’t remember for sure where I was reading about the blocking diode didn’t seem to work like it should I had my meter taped and wire to the frame while I was riding and thinking my reading was up toward 15 volts which I could not take a picture of this (maybe Alleyoop could help on this) Also after cutting the wire that goes to the alarm and whatever else it went to if I disconnect this wire the scooter will start but only a few seconds sounds like it ran out of fuel until reconnected so now I’m thinking about putting in a hidden switch to this links1375.photobucket.com/user/Robertban56/library/
|
|
Doc's Anything Goes
Currently Offline
Posts: 1,226
Likes: 81
Joined: Apr 4, 2014 3:52:42 GMT -6
|
Post by richardv on Oct 15, 2015 5:25:56 GMT -6
WOW! I wish I knew more about what your doing but it will have to wait until I get that scooter. Then there may be a lot of questions.
|
|
|
Post by Alleyoop on Oct 15, 2015 10:11:58 GMT -6
Very nice wiring setup BRO!! nice and neat and clean. GOOD JOB. Alleyoop
|
|