Senior Clinician
Currently Offline
Posts: 102 
Likes: 1
Joined: Apr 21, 2016 4:28:54 GMT -6
|
Post by icebear2009 on May 25, 2016 10:09:55 GMT -6
OK when I first got my trike the reserve mechanism was not bolted in so I took it off instead of loosing it I'm going about putting it back on but how do I know where the correct position is for the mechanism
|
|
|
|
Post by cyborg on May 25, 2016 12:01:38 GMT -6
Drop a line to Jim at rapid repair ,,, or give him a call,,, he's the resident icebear guru ,,, his ad is scrolling at the top of the page,,, he's an icebear dealer,,, very knowledgeable and general nice guy
|
|
|
|
Post by crwford on May 25, 2016 15:56:09 GMT -6
If you talking about the spline coming out of the transmission if shift is on side near floor. If you right now going forward keep leaver forward and slide linkage on shaft and use the locking screw the tighten it up and if you need to fine tune it look at end of linkage and adjust nuts forward or back.
|
|
Senior Clinician
Currently Offline
Posts: 102
Likes: 1
Joined: Apr 21, 2016 4:28:54 GMT -6
|
Post by icebear2009 on May 25, 2016 17:24:50 GMT -6
No its the style on the block I wish I had the other style
|
|
|
|
Post by crwford on May 25, 2016 20:15:11 GMT -6
can you take a picture of unit?
|
|
