Clinician
Currently Offline
Posts: 4
Likes: 0
Joined: Feb 6, 2018 6:58:54 GMT -6
|
Post by isayork99 on Mar 4, 2018 13:02:27 GMT -6
I have found a clutch cover i really like but it is made for a 150cc engine and from what i have found is that engine from corner blot to corner bolt is 363mm=14.3". But I have a 50cc engine and from what i found is that cover is 361mm=14.2". BUT that could be the difference in where the measurements we taken from end to end or center point to center point. Has anyone test fit or put a marked 150cc case on a 50cc engine or know if the Chinese would really make a 2mm difference cover?
|
|
|
|
Post by czmdiver on Mar 5, 2018 5:56:37 GMT -6
There are both a Long Case and Short case GY-6 motors There are a bunch of measurements online you will just have to sort thru them   |
|
Clinician
Currently Offline
Posts: 4
Likes: 0
Joined: Feb 6, 2018 6:58:54 GMT -6
|
Post by isayork99 on Mar 8, 2018 3:09:34 GMT -6
Thank you for the information , But what you are saying is that a long case cover off a 150cc motor is the same as a long case cover on a 50cc motor. I have found a lot of measurements and the best i can find is a 2mm difference.
|
|
|
|
Post by czmdiver on Mar 8, 2018 11:06:33 GMT -6
www.scrappydogscooters.com/Replacement_Parts.htmlCheck out the OE covers here. Showing the Short case 50cc has 8 bolts and the Long Case 50cc has 10 bolts. thats much more than 2mm distance.. And looking at the 50 covers on the Scrappy site above and owning a 150 I don't see that the covers are interchangeable.. Hope this helps
|
|
