SSR 150 Turino AKA ZNEN VES - Can't get tire back on spindle By binarychunk (Read 997 times)

[binarychunk]

SSR 150 Turino AKA ZNEN VES150
Old tire came off with slight bending out of lower fender - (was able to remove lower screws. #342)
Perhaps I need to remove entire fender to replace but can't figure out how to get at screw #359
Any help or guidance greatly appreciated

Thanks

[snaker]

Don't know anything about that design. The owners manual would normally give instructions for that sort of thing.
Other than that either remove body parts or;

If it has a typical coil over shock can you unbolt one end and lower the final drive for access?

[binarychunk]

Here's what I learned if you face similar issue:

1) Yes fender must come off to replace tire.
2) Release screw #359 (hard to get at)
3) Pop panel Locks

[cyborg]

Good tip binary,,,thanks,,,there's a piston right there