Clinician
Currently Offline
Posts: 17
Likes: 0
Joined: Feb 20, 2020 16:45:52 GMT -6
|
Post by ezed1 on Feb 26, 2020 23:10:35 GMT -6
2008 Jonway 250 to my surprise I open it up and A COVER with a seal and GREASE dark in color and sticky😕 ,I thought these things were suppose to be dry ,wasn't sure what to do so I cleaned it out really good and put back together with no grease, any thoughts ? Also there are rubber or plastic seals in the openings where the slide goes,I assume there to keep grease from coming out but it slows down the slide ,I did lube up the slide with some Magnalube i had laying around loosen it up quit a bit,mind you this is a project that i have not road yet everything i have done to it have been on its center stand ,fluids carb clean and currently trying to tune the carb with its no access air fuel ratio screw :-(
|
|
Clinician
Currently Offline
Posts: 17
Likes: 0
Joined: Feb 20, 2020 16:45:52 GMT -6
|
Post by ezed1 on Feb 27, 2020 7:23:00 GMT -6
2008 Jonway 250 to my surprise I open it up and A COVER with a seal and GREASE dark in color and sticky😕 ,I thought these things were suppose to be dry ,wasn't sure what to do so I cleaned it out really good and put back together with no grease, any thoughts ? Also there are rubber or plastic seals in the openings where the slide goes,I assume there to keep grease from coming out but it slows down the slide ,I did lube up the slide with some Magnalube i had laying around loosen it up quit a bit,mind you this is a project that i have not road yet everything i have done to it have been on its center stand ,fluids carb clean and currently trying to tune the carb with its no access air fuel ratio screw :-( forgot to mention that the grease seam to not serve any purpose because all of it was slung up and,away from the roller areas which were actually dry 😕
|
|
Clinician
Currently Offline
Posts: 17
Likes: 0
Joined: Feb 20, 2020 16:45:52 GMT -6
|
Post by ezed1 on Jun 21, 2021 17:41:21 GMT -6
Newbie back after a year or so , I went with no grease i cleaned out the old stuff coated the inside with graphite stray and went to sliders, haven't had any issues
|
|