New battery Gy6 won't electric, won't kick start, no lights By 954insul8r (Read 748 times)

[954insul8r]

I have a GY6 -2014 Bash Peace Sport 150cc scooter it hasn't been started in about 4 months give or take . So approximately 4
months ago the throttle tube cracked from cheap
plastic in the florida sun but other then that it ran great. That said it sat longer than expected now I finally got to fixing it. New throttle cable and throttle assembly which I upgraded so no more plastic , I also put a new battery in just because..
Here's my problem turn key on nothing happens and I mean nothing. No electric start, won't kick start , no tail light on or hazard lights, or blinkers absolutely nothing comes on .. I'm new to this and I'm at a loss!!! I'm hoping that someone here can tell me what it could possibly be?

[grrbrts]

Have you checked (tested) the fuse inside the battery compartment? I know you said the battery was new, but can you test it with a mulit-tester? Look for 12 volts and above.

[954insul8r]

Dec 13, 2020 17:43:37 GMT -6 grrbrts said:

Have you checked (tested) the fuse inside the battery compartment? I know you said the battery was new, but can you test it with a mulit-tester? Look for 12 volts and above.

The fuse inside the battery is fine & I'm getting over 12 volts when I test it with the multi-tester.
I still haven't figured out yet but I'm leaning towards bad ignition or kill switch related although it's just an educated guess at this point.
Any help is appreciated and I thank you for taking the time to give any input.. thanks again

[grrbrts]

If yours has a flame-out switch, check that it works by switching it on and off. If not working, replace that switch. Check to start button as well. Make sure both are getting fire, so to speak. 

[mattgy6]

I NEED HELP PLEASE!!!!!!!!!
I'm not getting any spark. I've bought a new battery cuz the old one went completely dead. Also bought new cdi, coil & plug wire, plug, and stator and still have nothing. I can't seem to find what I need on YouTube and I'm lost. I bought a volt meter and have been trying to test things but I can't figure it out. I'm not getting any lights when I turn the key either. The starter turns over wether the kill switch is on or off and also if the brake lever is pulled or not. Any suggestions is much appreciated. Thanks

[grrbrts]

"I'm not getting any lights when I turn the key either."

Okay, did you purchase the correct type of CDI? There is a DC fired and an AC fired. If you turn the key on and the lights turn on, then it is an AC fired. I await your reply.