Clinician
Currently Offline
Posts: 8
Likes: 0
Joined: Nov 21, 2010 16:50:56 GMT -6
|
Post by phrogman on Nov 28, 2010 16:59:47 GMT -6
Does a 2T have a traditional engine oil sump? I have found a plug and have found a fill port ( rubber stopper) Butg if I open the plug and drain the oil , I'm not sure that the fill port isn't for the grar box oil? THe fill port is all the way at the very end of the left side. I would hate to put engine oil in the gear box. I have a 50cc 2T Qungli with the D1E41QMB engine. thanks Phrogman
|
|
|
|
Post by Bashan on Nov 28, 2010 17:53:47 GMT -6
2Ts nowadays use oil injection right into the gas from a tank. There's a couple 2T manuals in the Tech section you should browse through. There's no oil sump like a GY6 but you have to determine where the oil injection reservoir is. It sounds like you may have found it with the rubber stopper, gear oil would have a bolt. The gear oil will still go at the rear so I don't think your in any danger of putting the wrong thing in the wrong filler. Read over the manuals, I think they'll explain everything. Rich
|
|
