Certified Clinician
Currently Offline
Posts: 82
Likes: 0
Joined: Feb 26, 2011 16:59:51 GMT -6
|
Post by skooter on Mar 7, 2011 19:14:32 GMT -6
cool going to try that, also there is a copper plug over my air/fuel mix screw. I just read somewhere i could drill that out, im cautious about drilling into my carb. Did i read that right? Carbs are cheap enough that you may want to buy one from EBAY or a site on the sponsor list of this site. It's better to try an experiment with an extra part then to have down time with your current set up. |
|
|
|
Post by Alleyoop on Mar 7, 2011 19:40:04 GMT -6
It is not a big deal taking the CAP off the Air/Fuel mixture. Just take your Carb off get a small bit like a 1/16 and drill in the Center of the CAP and Just Break the Cap, Not much pressure is needed to make a little hole through the CAP. Then take a small screw and screw it just enough that it grabs the CAP and get a pair of pliers and pull if off. Remember the Air/Fuel Mixture is right under the CAP so you just want to break through the CAP do not drill further.
Alleyoop
|
|
..BAD TO THE BONE..