rear axles By ironworks (Read 1,211 times)

[ironworks]

i was wondering if anyone knows what the rear axle end play should be on a 2010 ice bear compellor.also what the torq should be on the nuts that hold the rear hubs on.if anyone has any info that would be great.also one more thing how much fluid goes in rear differential and transmission.

thank you for the help

[Alleyoop]

Do the hubs have a Cotter Pin going through the Axle? If so just tighten them up so that the hub does not move otherwise the wheel will wobble and ruin the Spline on the HUB they are not made of real hard metal. The fluid probably you will have to measure it when you drain it. Not a hell of a lot though it is a Splash system so probably only about 200-300ML oil.
Alleyoop

[ironworks]

so what you are saying there is no end play.tighten castle nut until there is no wobble or movement.also what is the oil viscosity for the transmission & rear diff.

thank you
custom iron works

[Alleyoop]

Yes, you do not want any movement of the HUB at all, that means it is LOOSE.

The tranny oil I use 75/90 Full Syn. The Crankcase oil any Good 10w-40 oil, after break in over 1000miles I am now using Castrol GTX 10w-40 Full Syn.
Alleyoop

[rapidjim]

Yep

[Alleyoop]

Jim,
I will be there but this DAMN weather is not giving me two nice days to make the trip. It is an open Motorcycle Trailer from U-Haul and I need to pick it up ONE NICE evening bring it home get the Trike on it and strapped down. Then early the next morning make the jount up to you and get there in the afternoon before you close.
When we come Hope you are able to Join us for Supper and Down a FEW at a good CHOW place in your area ON ME. So tell your better half IF you have one that it will be a night out with the guys from CHI.
Alleyoop

[ironworks]

thankyou alleyoop

from ironworks