Roketa 54b 250 crankcase cover By fnshnegrl (Read 831 times)

[fnshnegrl]

Hi,
I am in the process of replacing the Drive Axle on my Roketa.
I have all the bolts out of the crankcase cover but was wondering if there is a special trick to getting it off. I know there's a gasket or seal but I can't seem to pull the cover off. Thank you in advance for any and all help.

Sincerely,
fnshnegrl

[Alleyoop]

Don you mean the TRANNY cover plate with the Clutch Pulley axle attached to it? The cover has about 7 bolts holding it on. Just wiggle it around a little it should pull striaght out. Probably the gasket is holding it on give it a couple taps to loosen it.
Alleyoop

[ce]

Smack it hard with a big rubber hammer or a stout piece of wood. You won't hurt it and you need to break it loose and then wiggle it free. Bang on it all over, it'll come off.