PST150_7t By Alleyoop (Read 1,015 times)

[roguesquid]

I bought this scoot off of the chaplain in my command . This is a 150cc trike not sure what engine though. The issues i noticed that i dont know how to fix is grease from the rear diff is comming out of one of the holes. Only one hole spews the grease. So i dont know if i need to replace the diff and drive axles or is there a quick fit for this??

Also i cannot seem to find the brackets to hold the body onto the frame. Is there a way to get the screws and brackets???

[Alleyoop]

Welcome to the forum Roguesquid,
Not to worry the hole your talking about is probably the Grease Fitting is missing. You can go to an auto parts store and pick one up and screw it in.

I don't understand what you are looking for when you say the Brackets to the Body onto the frame?? Are you talking about the rear fender and or center piece or what??
If you could take a picture of what your looking for or talking about that may help figure out what your trying to do.
Alleyoop

Is this your TRIKE?


Here is the Probably what your missing THE GREASE NIPPLE and the grease is coming out.

[Alleyoop]

The motor is most likely a 157QMJ that is what Ice bear 150 trikes come with. Same motor I have in my trike.
Alleyoop

[Alleyoop]

Take some pictures of your problem so I can see what is wrong.
Here is what the rear axle looks like taken apart so you know the parts it is made up of.
Alleyoop


If grease is coming out of the Rod that holds the two Worm Gears then the Shims on each side on the ROD are shot or one of them.

Here is what I am talking about, I labeled where you say grease is coming out and I labled where the shims are on the ROD:

[roguesquid]

I have a rubber grommit there. I sent pic but i dont know if they came out. Not sure how to post pictures on this forum.

[Alleyoop]

Use photobucket it is free load up your pictures there and then click on share and go down to the IMG section copy the link and paste it on here.
Alleyoop
photobucket.com/

[Alleyoop]

Here is a HOW-TO post Pictures and or Videos.
Alleyoop
www.scooterdoc.proboards.com/index.cgi?board=talk&action=display&thread=5581

[roguesquid]

[roguesquid]

Who has these shims and where can I find a diagram for the project? Was sortta thinking putting an dab of silicone on the shim head for an temp fix, then repack with white grease.