How to remove front bearing? By richardthescooter2 (Read 862 times)

[richardthescooter2]

It is for sure my front bearing. My question is how do you remove the bad bearing, is there any video's?

Attachments:

[Alleyoop]

Here you go Richard,
Part1 and Part2 with no special tools.
Alleyoop

[richardthescooter2]

Thanks Alleyoop, going to work today I notice a thumbing and scraping, I got my friend from church come and haul my scoot home.

[richardthescooter2]

Got wheel off trying to get bearings out there is a spacer in my axle, so its hard to hammer out the bearing, now I can push the spacer a side some what, got any ideas (I have the mc-54-250b roketa scooter).

Attachments:

[richardthescooter2]

Got them out, now where to buy them?

[Alleyoop]

Get the number off of them and google for bearings with that number. You will get a lot of hits they are very common size.
Alleyoop

[richardthescooter2]

Tried local bearing place $17.00 each!!!!

[richardthescooter2]

Found set of two shipped for $10.00

[richardthescooter2]

Does anyone know what the torque setting for the front axle nut?

[ridecheap]

Oct 23, 2012 7:39:08 GMT -6 richardthescooter2 said:

Got wheel off trying to get bearings out there is a spacer in my axle, so its hard to hammer out the bearing, now I can push the spacer a side some what, got any ideas (I have the mc-54-250b roketa scooter).

Same ride and when I replaced my front tire those bearings just poped out and regressed them. Thats pretty weird that its just stuck in there and you cant get it out.

[ridecheap]

Oct 25, 2012 10:11:12 GMT -6 richardthescooter2 said:

Does anyone know what the torque setting for the front axle nut?

I just did it until I thought it was tight lol no torque wrench too poor.

[richardthescooter2]

The one came out pretty easy, but the other was hard. Just waiting for bearings to come (hopefully today) thanks.

Attachments:

[ridecheap]

Oct 25, 2012 10:45:33 GMT -6 richardthescooter2 said:

The one came out pretty easy, but the other was hard. Just waiting for bearings to come (hopefully today) thanks.

When I took my front wheel off I put two jacks on the front metal part where the wheel goes. I then put the back on its stand.

I hope you get back out and ride. This scooter loves the Wisconsin Cold. I am going to ride it till it snows 5 inches probably.

[richardthescooter2]

I rode about all winter last year, hope to do the same this year, (Have fun and ride safe). I have miner on a car jack, board on top and I have it on the center stand. The bearings I got are sealed.