Head Studs By Gti (Read 453 times)

[Gti]

I have gotten close to the end of the build of this engine and I just noticed a problem with the head studs. I know there are two sizes but with my BBK and stroked crank should they all be the same size? Which side does the longer studs go on and which "way" is up? There is a long shank on one end and a small one on the other.

[Alleyoop]

Take a look at Richs Project see if that helps you:
Alleyoop
www.scooterdoc.proboards.com/index.cgi?board=techtips&action=display&thread=6884&page=1

[tvnacman]

The studs that you attach the intake maninfold and exaust or the ones for the jug and head .

John

[Alleyoop]

If your talking about the studs that screw onto the CASE the ends with the MORE THREADS go into the case.
Alleyoop

[Gti]

Here are a few pics of the studs. I have a new set on order but I do know there are two lengths 195mm and 200mm one side is longer then the other. I can not remeber which side is which and there is a shank on the top and bottom of the stud. Which mounts to the block and which goes towards the cam retainer?

[Alleyoop]

THE ENDS with the LONGER SHANK goes up to clear the ROCKER ARM ASSEMBLEY. The Ends with the SHORT shanks screw into the CASE.
Alleyoop