crankshaft By mctojs (Read 414 times)

[mctojs]

Good day everyone!
may I request for your input regarding this problem I have... Recently i replaced my crank bearing, but I noticed a side play after its installation. . . I suspected this culprit. . a misplaced washer/spacer. . is this washer in right position?



DSC01382 by tojobriva, on Flickr



is it really between crank bearing and timing chain sprocket or placed between the bearing ang crank. . Thank you very much!

[Alleyoop]

Yes, I have never seen a washer against the bearings like that.
Here are good pictures of the Crank on Rich's Tear down and Rebuild project.
Alleyoop
www.scooterdoc.proboards.com/index.cgi?board=techtips&action=display&thread=6884&page=1

[mctojs]

Jan 22, 2013 11:44:44 GMT -6 Alleyoop said:

Yes, I have never seen a washer against the bearings like that.
Here are good pictures of the Crank on Rich's Tear down and Rebuild project.
Alleyoop
www.scooterdoc.proboards.com/index.cgi?board=techtips&action=display&thread=6884&page=1

Thank you very much sir Alleyoop. . .
I really don"t see any washer/spacer between the gear and bearing .. Do you have any idea where that thing should be placed?

[Alleyoop]

If you look at Rich's Crank there is a thick washer on both sides next to the Bearings. But that washer LOOKS like the one you have on the OUTSIDE next to the sprockets.
Alleyoop