Clinician
Currently Offline
Posts: 4
Likes: 0
Joined: Jun 26, 2013 8:00:51 GMT -6
|
Post by lobo14 on Jun 26, 2013 8:15:18 GMT -6
I have a 2010 YY250t and I took the brakes pads off to check them and put them back on. Went to start it up and ride around and it wouldn't start. I have lights, and horn but when I hit the start button there is nothing... no sound, just nothing. I checked and charged my battery, that didn't fix it. I thought it may be the spark plug, I checked it seemed bad enough to change so I did. Still same results... lights, power... no action. My next thought is a bad starter?! I'm new at this but reasonably handy with my hands... Any ideas/ help would be greatly appreciated.
|
|
|
Post by kz1000st on Jun 26, 2013 8:25:44 GMT -6
Check the kill switch. You might have turned it off putting the bike on the center stand.
|
|
Clinician
Currently Offline
Posts: 4
Likes: 0
Joined: Jun 26, 2013 8:00:51 GMT -6
|
Post by lobo14 on Jun 26, 2013 8:30:04 GMT -6
Kill switch? I did put it on center stand I didn't know there is a kill switch? where would it be located and look like?
|
|
Clinician
Currently Offline
Posts: 4
Likes: 0
Joined: Jun 26, 2013 8:00:51 GMT -6
|
Post by lobo14 on Jun 26, 2013 8:44:02 GMT -6
The kill switch on the handlebars? I checked that
|
|
Scooter Doc
Currently Offline
Posts: 387
Likes: 0
Joined: Feb 26, 2011 8:30:23 GMT -6
|
Post by bobf on Jun 26, 2013 12:57:13 GMT -6
On my YY250T with the 244 cc engine the kill switch is the red slider switch just above the yellow start switch. .
|
|
|
Post by kz1000st on Jun 26, 2013 15:22:32 GMT -6
Does that scoot have a side stand switch? Make sure that's not hanging open.
|
|
Clinician
Currently Offline
Posts: 4
Likes: 0
Joined: Jun 26, 2013 8:00:51 GMT -6
|
Post by lobo14 on Jun 28, 2013 22:57:25 GMT -6
I found the problem... a wire wiggled loose on the kill switch side therefore causing the issue. Fired right up.... thanks for your help.
|
|
Clinician
Currently Offline
Ret. Federal Police
Posts: 30
Likes: 0
Joined: Aug 4, 2012 10:13:32 GMT -6
|
Post by abracy on Jul 7, 2013 9:44:38 GMT -6
Hello! I hope I'm putting this in the proper place. I looked all over this site to find someone with a bike that looks like mine, well here goes. I have the same engine as in the photo here. (2012 Jonway YY250T 244cc) I was having dead batt issues since I bought the bike (brand new) a little over a year ago. So I bought a new batt. and still the same issue. So I checked the output of my charging sys. and discovered that it was not charging AT ALL. I purchased a brand new stator for $90.00 which I found cheaper after the fact on another site. (49.00) My problem is WHERE IS THE STATOR LOCATED? The place I bought the bike from stated that all I had to remove was the muffler and BAM there it is. NOT TRUE. Can someone please help me locate the stator so I can R&R it so I can get back on the road again. (It's been a month of not riding.) Arrrgh
|
|