Taotao Headlights By fljohnboy (Read 1,805 times)

[fljohnboy]

I just bought a 2012 Taotao 150 Lancer. I noticed that one headlight only lights up high beam with switch in high position. This scooter has headlight bulbs and when I took the fairing off the front the 2 bulbs are not the same. I don't know if it suppose to be that way or not. One bulb has 2 male ends right out of the center of the bulb like a high and low but the other bulb has just one terminal out of the center and the other is on the side like a ground. Can anyone shed some thought about this. Also, on the right side below the bike there's a plug with 2 wires not attached to anything, they're green and white.

[epyon96r]

The green and white wire is it by the floor board or enigine area? And is it green and white. Or is it green with white/black

[fljohnboy]

floor board, it's green and white/black picture below

[epyon96r]

I ok, that's what I was thinking. I have that and its not connected to anything and I have not seen anything it would connect too. I have had absolutely no problems with my scoot with that wire not co nnected to anything, so I just tiewrapped it to the frame.

[epyon96r]

Though my wire is by the right of the engine

[fljohnboy]

Ok thanks. I was thinking that maybe some models have a sidestand switch that won't let the bike start when it's on the sidestand.

[Bashan]

I started you a new thread 8744675, you can access it right here. On forums when you have a problem of your own to discuss you should start a new thread. This is kind of a gray area in that you can mention your own problem and how it pertains to the thread you're commenting on. But if you wish to get advice about your issues you should start a thread. No harm, no foul, we were all new to forums at one time, just FYI. Rich