Flywheel 11 pole v/s 8 pole By scatterbrained (Read 1,865 times)

[scatterbrained]

Hi I'm new to the forum and might not be in the right place for this question. I'm kinda new to the gy6 engine and I'm looking to convert to the 11 pole stator set up since I can't find the elusive center tap stator to replace the original. My question is this.... Will my 8 pole flywheel fit an 11 pole stator? The id of the flywheel is 3.555 in. Or 90.297 mm. Thanks for any help.

[Bashan]

Welcome to the forum. I'm going to move your thread to 50cc to 200cc tech where it will get more eyeballs. I've been up and down the pike on your topic. If you need a replacement for your OEM stator (original) just order a stator with the same number of coils. That's usually 8 on a 150cc. The flywheel MUST match with the same number of coils. If it's an 8 coil stator you're using you must get an 8 coil flywheel. It's a matter of the magnets matching up. Now, an six or eight coil GY6 stator is center tapped unless you rewire it and remove the center tap ground. If you need an 8 pole stator and flywheel it will be center tapped. The 11 pole system is three phase with three yellow wires. I wouldn't just jump to that unless you know what you're doing. If you need an 8 pole stator, order one, it's center tapped and will have a yellow and white wire, not three yellow. Make sure the bolt hole measurements are the same on the stator.