valve adjustment replacement questions By danny (Read 516 times)

[danny]

so I upgraded my 49cc with a 100cc big bore kit from ebay and the kit included new rockers for the valves and I could not get one of the rockers out from the rocker assembly so I had to leave it in so only one was replaced. I am wondering if its ok to drill a hole on the other side of the pin that holds the rockers in place so that I can push the pin out from the opposite side because it seems that no matter what I do, I cannot pull it out normally. I tried screws but they all stripped and I cannot just tap it until it falls out. 
If not, is it ok to turn one of those valve screws upside down because with only one rocker replaced, there isn't enough meat on one of them to keep the nut on without the valves being too loose. 

Your input is appreciated

[jct842]

Best post a picture of what you are talking about. Hard to visualize with out a head in front of us.

[danny]

[cyborg]

I would do the drill hole and drift punch it out ,,, you're asking for trouble doing the upside down adjuster

[danny]

Thank you!

[danny]

drilled hole and testing soon. Im sure I still have the other issue still going on though which I can't seem to figure out. Read about that in my other thread in this same forum and answer if you can

[danny]

Drilled hole method worked good and the other problem has also been fixed. It was the air mixture screw needed turning. Thanks

[cyborg]

Good job,,,there's a piston right there