electrical problem on my 2012 1ce bear trike By raydozois (Read 1,254 times)

[raydozois]

Live on Daytona Beach, and had a family emergency over the holidays. we were gone for a couple of weeks and when I got back I went to start my trike and it wouldn't fire. I turned thr kill switch back off and on, and it started to fire and didn't start, so I began to flip the switch off and on and finally it started up and ran at idle for about 10 or fifteen minutes. It was running smooth so I shut it off and tried to start again and same problem. I played with the kill switch some and every so often it would try to start ( start to fire). Well I checked everything in the ignition circuit. I removed the kill switch and if I play with the disconnected wires, connecting and disconnecting while engaging the starter it will fire and sometimes start but when I shut it off it won't start again. I've cleaned all connections because of corrosion from salt air, but no solution. Any Help is appreciated

[tvnacman]

what engine size?
what model trike?

John

[raydozois]

Sorry for not answering been away for a few days. Death in the family and leaving for funeral. I have a 2012 ice bear trike 150cc. If I play with the kill switch it will start to fire sometimes it will run but when i shut it off it does the same thing. Being on the ocean does a number on the trike. I think I have a bad ground somewhere or some bad connection. Anybody have a problem like this. I swapped out the cdi and still the same.

[cyborg]

I would think the problem is in the switch you were fiddling with,,, perhaps its corroded

[vlxerdon]

Have to agree. Sounds like the kill switch is where the problem is.

[raydozois]

Hey Guys, The family issues took quite a bit longer than anticipated. I am going to get back into the trike electrical problem starting tomorrow. I will let you know what I find.
Thanks,
Ray