Post by Alleyoop on Apr 12, 2010 19:56:47 GMT -6
Hi Troops,
When making turns I always put my turn signals on. The problem was that I would make the turn and forget to turn off the Turn Signal. Sometimes I would go for a block before noticeing that the Turn Signal was still on. So I bought a Universal Turn Signal Beeper from here:
www.rvtoys.net/motormate_002.htm
The Beeper has three wires Two Red wires connect to your left and right turn signals and one is Ground. The Red wires already have Diodes in the wires.
How to connect:
On your Left Handlebar there are about 8 wires inside a rubber tubing for protection. The Orange wire is for your left Turn Signal and a Light Blue is for your Right Turn Signal. Connect one of the red wires from the Beeper to the Orange wire coming from the Left Handlebar and connect the other red wire from the Beeper to the Light Blue Wire coming from the Left Handlebar, Then connect the Black Ground Wire from the Beeper to any good ground and your done.
Decide where you want the Beeper because you may need to add wire to the wires from the Beeper to extend the reach. I put mine right in the Center of my Handlbar Cover and the wireing for the Left Handlebar are right there so I did not have to add any more wires to the Beeper. Also If you find it to loud just take some tape and tape part of the top of the Beeper to muffle the Beeps.
Alleyoop
When making turns I always put my turn signals on. The problem was that I would make the turn and forget to turn off the Turn Signal. Sometimes I would go for a block before noticeing that the Turn Signal was still on. So I bought a Universal Turn Signal Beeper from here:
www.rvtoys.net/motormate_002.htm
The Beeper has three wires Two Red wires connect to your left and right turn signals and one is Ground. The Red wires already have Diodes in the wires.
How to connect:
On your Left Handlebar there are about 8 wires inside a rubber tubing for protection. The Orange wire is for your left Turn Signal and a Light Blue is for your Right Turn Signal. Connect one of the red wires from the Beeper to the Orange wire coming from the Left Handlebar and connect the other red wire from the Beeper to the Light Blue Wire coming from the Left Handlebar, Then connect the Black Ground Wire from the Beeper to any good ground and your done.
Decide where you want the Beeper because you may need to add wire to the wires from the Beeper to extend the reach. I put mine right in the Center of my Handlbar Cover and the wireing for the Left Handlebar are right there so I did not have to add any more wires to the Beeper. Also If you find it to loud just take some tape and tape part of the top of the Beeper to muffle the Beeps.
Alleyoop
..BAD TO THE BONE..
Where the heck have you been 
I would be on a 4 way corner and everyone on all four corners could hear I was turning 
