CDI location on my scoot By rugged (Read 2,140 times)

[rugged]

Unable to find the CDI on my scoot, znen 150T-18 GY6-B engine,

anyone have a schematic?

[jhbietz]

I don't have a diagram but the only places I have seen them are on the frame rails under the seat or under the "step through" AKA floorboard.

[rugged]

thanks, I didn't check floorboard.

[Alleyoop]

Another way to find it follow the wires that are plugged into your COIL. They will probably be wrapped up with more wires but at least you can see where the wrapped wires go and it should be somewhere along that string of wrapped wires.
Alleyoop

[rugged]

I did a little of that, that's how I learned the coil wire I bought was not 1 prong. Unlike the one ordered and received from scrappydawg. Hoping I can find and use the new CDI, money wasted otherwise.

[Alleyoop]

Rugged,
So your Scoot Coil has only 1 Connector and the COIL itself has to be grounded is that it?
Alleyoop

[rugged]

Didn't have any thoughts about the grounding ,but it is true that the stock scoot coil wire is a 1 prong/connector and the one I bought has two prongs/connectors.

I say 1 prong because that is how it is described once I found it on scooterparts4less.com

[rugged]

Hey Alleyoop, I didn't fully understand your comment about ground, but this morning I saw that my "1 prong" coil has a frame ground instead if a second prong, so I realize I can with a small adjustment modify the new coil.

I never did find the cdi, I'll look for it again soon, but today was the first nice day in a few days so I RODE.

Thanks for your help