Getting to Tail Lights on MC-62-250 By damin69 (Read 860 times)

[damin69]

Ok does anyone know an easy way of getting to the Tail lights on the MC-62-250/VOG 260 short of pulling out the Under seat compartment?

[Jeff]

Todd, if you haven't figured this out already, there is an access panel you can remove from underneath to access the rear lights. I can explain and/or post a picture or two to show you.

[260orbust]

Really?? I had no idea it was there.

[damin69]

May 19, 2011 20:59:42 GMT -6 Jeff said:

Todd, if you haven't figured this out already, there is an access panel you can remove from underneath to access the rear lights. I can explain and/or post a picture or two to show you.

Nope sit did not figure out there is a panel below to remove I finally pulled the box from inside to get to them. I have to back in again cause I got the wrong LED brake lights.

[Jeff]

I'll take a couple of pictures Saturday morning.

[Jeff]

With rear plastic off the scooter, you can see the 4 attachment points. 2 screws at the bottom and the top 2 are the hard plastic into soft rubber o-ring type things, same as you have around the headlights. Need to remove the 2 screws and then wiggle the rest of it out. On mine one side just about fell out, the other took a fair amount of wiggling to get it to pop out.

Attachments:

[Jeff]

With the cover removed

Attachments:

[Jeff]

Plastic upside down showing view from outside. You should see this access panel right at the bottom of the tail light lens.

Attachments:

[damin69]

Cool Thanks Jeff. I will give that a try I have put my Brake LEDs in anyway.