Vento GT5 instrument question By captonzap (Read 861 times)

[captonzap]

On a 2006 Vento GT5 instrument cluster housing, there are three small holes in the plastic housing, under the center mounted gas gauge, and they seem to have a push on/push off switch under each of them. Does anyone know what function they serve?
Thanks, CZ

[Bashan]

If you can post a pic of your dash with the holes circled so we know what you're talking about it would help a lot. We did have a guy on the forum with a Vento and here is a pic of his dash. I circled what may be similar to what you're in question about. I think that's the gas gauge above them. This may be an aftermarket dash though, I'm not sure.

[captonzap]

May 11, 2013 6:13:32 GMT -6 Bashan said:

If you can post a pic of your dash with the holes circled so we know what you're talking about it would help a lot. We did have a guy on the forum with a Vento and here is a pic of his dash. I circled what may be similar to what you're in question about. I think that's the gas gauge above them. This may be an aftermarket dash though, I'm not sure.

Sorry for the delay. I don't have a way to take or post pictures, but the one shown is the same one I'm asking about.
The three holes circled have push on/off switches under each hole.
I haven't found anything they affect, but then I may not have looked in the right place.
Yes, the gas gauge is directly above the holes, and it is a digital masquerading as an analog gauge. There is some fine marking under each hole, cast into the plastic, so I am guesssing that it is OEM.
Thanks for the effort on the pictures, CZ

[Alleyoop]

I am sure two buttons are to set your clock and the other is to reset the ODMETER to zero.

Alleyoop

[davec]

May 18, 2013 16:52:46 GMT -6 Alleyoop said:

I am sure two buttons are to set your clock and the other is to reset the ODMETER to zero.

Alleyoop

I was just gonna say that
Really! !!!!