|
|
Post by redroush00 on Oct 7, 2013 16:35:18 GMT -6
When i adjusted my needle and put the diaphram back in the carb it seems that the outer edge wont go back into its slot. Is there a trick to doing this so the lid doesnt pinch it?
|
|
Senior Clinician
Currently Offline
Posts: 167
Likes: 2
Joined: Jun 4, 2011 10:43:50 GMT -6
|
Post by gatekeeper on Oct 7, 2013 17:45:02 GMT -6
If you got cleaning fluid on the diaphragm it will swell up. After setting for a while and drying out it should shrink back down and fit. At least that is what happened with mine.
|
|
|
|
Post by redroush00 on Oct 7, 2013 17:54:08 GMT -6
No fluid. Just removed it. There was gas on it though.
|
|
Senior Clinician
Currently Offline
Posts: 167
Likes: 2
Joined: Jun 4, 2011 10:43:50 GMT -6
|
Post by gatekeeper on Oct 7, 2013 19:03:00 GMT -6
Pretty much the same thing. Let it dry for a while and it should shrink to fit.
|
|
Clinician
Currently Offline
Posts: 10
Likes: 0
Joined: Oct 3, 2013 13:14:01 GMT -6
|
Post by freefour on Oct 8, 2013 6:14:15 GMT -6
I had the same thing when I adjusted the needle . I took the carb off , put my finger in the throat of the carb pushing the slide up while also fitting the diaphragm back in its grove . Put the top on and started the screws and with a q-tip ensure the lip was in the groove all the way around . Buttoned her up and was fine .
|
|
