dr pulley sliders By moparkid58 (Read 1,405 times)

[moparkid58]

Howdy all. I have a 1985 Honda 150 Elite that we've owned forever and I have decided that since we got a couple of new maxi scoots I would now do a few mods on the ol' elite, starting with changing out rollers for sliders. Any idea what weight and size I need? Thank you.

[trailheadmike]

Hi. This is not my scooter, but I was curious after your question and found several sites that say "the ’85 Elite 150 takes 20×15 roller weights." I also found a link to a repair manual in case you find that helpful.

www.hondaspree.net/other/Elite_CH150-H_Service_Manual_85-86.pdf

I'll post again if I find something more definitive. I did not read the manual but i'm sure its in there somewhere.

-Mike

[trailheadmike]

Here's the oem part number: 22123-KN7-671

Maybe you can find a site that has the spec for them.

[tvnacman]

I bet the variator for the Chinese eith the 16" wheels is the same .

John

[macosman]

reviving an old thread...
i just purchased an elite 150 deluxe with 11k miles. I have not been able to find any info directly from honda on the weight for the 150. I have read where the weight of the 250's is 22gr. I pulled mine and they are weighing on a digital scale at a whopping 26grams! I don't know if they are factory or not. 
I was running a good 62mph on flats with the current config.

Based on what i read it looks like most people are putting 11 or 12 gram rollers in. I'm going to install 12's and see what happens.