|
|
Post by Alleyoop on Oct 13, 2011 15:27:09 GMT -6
BUMMER!! Well lets wait until your battery is charged up and see if the scoot starts and if the back wheel is spinning. If it is then you will have to take the Clutch off and see what the hell is the problem. The hold thing is just held on by that one nut But it may be a PITA to get it off whatout a IMPACT WRENCH.
Alleyoop
|
|
Scooter Doc
Currently Offline
Posts: 912
Likes: 1
Joined: Feb 22, 2011 18:21:11 GMT -6
|
Post by straightbangin on Oct 13, 2011 15:29:35 GMT -6
Oh geeze that is a scary sounding wrench. Its charged up. I'm going to go film what goes on after i put the cvt cover back on, then it will take like 10 min for it to upload on youtube cuz its slow, so give me about 15 min.
|
|
|
|
Post by Alleyoop on Oct 13, 2011 15:35:16 GMT -6
COOL, will wait for your Video.
Alleyoop
|
|
Senior Clinician
Currently Offline
Posts: 160
Likes: 0
Joined: Oct 10, 2011 19:38:46 GMT -6
|
Post by raford3 on Oct 13, 2011 15:36:26 GMT -6
A small jump box is about $30 at Wal Mart. I think they have your battery for about $35.
|
|
Scooter Doc
Currently Offline
Posts: 912
Likes: 1
Joined: Feb 22, 2011 18:21:11 GMT -6
|
Post by straightbangin on Oct 13, 2011 15:44:02 GMT -6
LoL. Radford I've been out of work for 2 yrs due to a car accident injury and just starting to get back so money is tighter than a virgin right now ( only the essentials )  Made a great video and its uploading now It started, I was kinda shocked, but it gave me the same crap about 1/8th of a block from my place w the bogging and not accelerating w out threatening to shut off then it did  Back wheel was not spinning when I started it but spun when I gave it gas (obviously ) Holy slow upload, it says 31 min remaining on the upload. Uggg. Get out the popcorn I think the video is about 7 min long. I had to put the camera in the scooter pocket for a minute to push the scoot out onto the road. It was in the driveway infront of 2 trucks so I needed some room. Sorry for the delay there. |
|
|
|
Post by Alleyoop on Oct 13, 2011 15:51:41 GMT -6
Great, by the way you can get a Car Oil Filter Wrench the biggest one they have that will fit over the variator and or the Clutch bell to the Variator Face plate and or Clutch Bell to get the nut off. They also have them in a STRAP kind made like out of the belt material which also works INSTEAD OF AN IMPACT WRENCH..LOL Alleyoop  |
|
|
|
Post by Alleyoop on Oct 13, 2011 15:53:47 GMT -6
Well that is some good news, it starts and it runs and it moves. Great, by the way you can get a Car Oil Filter Wrench the biggest one they have that will fit over the variator and or the Clutch bell to the Variator Face plate and or Clutch Bell to get the nut off. They also have them in a STRAP kind made like out of the belt material which also works INSTEAD OF AN IMPACT WRENCH..LOL Alleyoop |
|
Scooter Doc
Currently Offline
Posts: 912
Likes: 1
Joined: Feb 22, 2011 18:21:11 GMT -6
|
Post by straightbangin on Oct 13, 2011 15:54:39 GMT -6
Damn I can't just unscrew the nut w a socket wrench? LOL! Oh in the video you will see a rubber band tieing back a hose from near the cvt cover to the licence plate. Don't mind that, it was just to hold the hose out of my way when I was looking under where the cvt cover was, the hose usually goes around it all and has lil things that hold it back. 29 min remaining on the vid. My apt comes w/ fast internet connection too so must be youtube's fault .
|
|
Senior Clinician
Currently Offline
Posts: 160
Likes: 0
Joined: Oct 10, 2011 19:38:46 GMT -6
|
Post by raford3 on Oct 13, 2011 15:56:01 GMT -6
When you attempt to kick start, rotate the engine until your'e on the compression stroke, (feel an increase in resistance) then start the attempt to kick it over from there. I have also found it helpful to raise the angle of the lever from horizontal to about 15 degrees above horizontal. I have a feeling you need to master this technique.
|
|
|
|
Post by Alleyoop on Oct 13, 2011 16:00:11 GMT -6
Good tip, you get more leverage plus more of a turn on the crank.
Alleyoop
|
|
Scooter Doc
Currently Offline
Posts: 912
Likes: 1
Joined: Feb 22, 2011 18:21:11 GMT -6
|
Post by straightbangin on Oct 13, 2011 16:00:29 GMT -6
LoL. Raford, luckily I got it started w/ out the kick start. My last scooter I kick started it daily for about 3 months before I broke the kick start because the starter button wasn't working and I wasn't into fixing scooters then. So I have it pretty well mastered Thanks for the tips though  I just realized that you can barely hear what Im saying after I start the scooter over the noise from it, oh well, I'm pretty much just rambeling and the video SHOWS what it needs to anyway. LOL. It says 22 more min on the upload. |
|
|
|
Post by Alleyoop on Oct 13, 2011 16:02:06 GMT -6
crap, think I will go take a shower.LOL
Alley
|
|
Scooter Doc
Currently Offline
Posts: 912
Likes: 1
Joined: Feb 22, 2011 18:21:11 GMT -6
|
Post by straightbangin on Oct 13, 2011 16:03:20 GMT -6
Go for it Alley |
|
Senior Clinician
Currently Offline
Posts: 160
Likes: 0
Joined: Oct 10, 2011 19:38:46 GMT -6
|
Post by raford3 on Oct 13, 2011 16:05:25 GMT -6
My father told me when I was about 10 years old, "Boy, DON'T FIX IT IF IT AIN'T BROKE!" after I took the lawnmower apart for no reason.
|
|
Scooter Doc
Currently Offline
Posts: 912
Likes: 1
Joined: Feb 22, 2011 18:21:11 GMT -6
|
Post by straightbangin on Oct 13, 2011 16:08:25 GMT -6
I grew up in a family of contractors, I didn't want to play with toys I just took everything apart. My fave " toy " was a phillips screw driver and I'd run around the house unscrewing everything when I was about 4. I would giggle with delight when my grandpa would set something down on a table and I got to watch it fall apart Snapping blue chalk lines was fun too 6:17pm Eastern Time - 5 min left on the video upload LOL |
|
..BAD TO THE BONE..
