Trike frome 50cc to 150cc By trevnar (Read 6,170 times)

[trevnar]

New T motorsports 150cc to go in the 50 frame lol only 3 brackets i gess kneed to be canged but i can weld but only hookup prob i got is the plug for the comp lol

Guna start on it tonight wish me luck ile post pix along the way and if u guys have any input it would be very much appreciated

Attachments:

[trevnar]

Would anyone have any top mount ideas ?

[Alleyoop]

Trevnar,
I sent you pictures of my frame with the motor out and motor in. Notice the motor mounts to the Rear Swingarm, the Motor has to move up and down with the Axle.
Alleyoop

[trevnar]

Lol guna post up alot of pix as i go

[Alleyoop]

Good luck man, that sucker is going to fly with the 150(HEHE).
Alleyoop

[mike6736]

Yes....but how stable will it be at higher speeds???

Mike

[trevnar]

I think i might make some wheel spacers for the rear and lagthin the frunt forks out a little and lower the hole thing like an inch or so

[trevnar]

First prob lol rear mout not guna work lol

Attachments:

[trevnar]

Took the rear swing arm off to make it all easer to weld

Attachments:

[trevnar]

👍

Attachments:

[trevnar]

This engine is massive in there

Attachments:

[trevnar]

Can i leav it like this with no head plastics on there for more clearance or will it over heat without it ?

Attachments:

[Alleyoop]

you need the plastics it will overheat on you and seize or and make mince meat of your piston.

Also the Drive Shaft when you put on the Drive SPROCKET does it line up with the sprocket on the Axle?
Doesn't look like it does.
Alleyoop

[trevnar]

Lol its not mounting like that lol and ok

[trevnar]

Guna do all the welding and stuf on Saturday