|
|
Post by heruk on Nov 23, 2014 15:35:04 GMT -6
ill check that
|
|
|
|
Post by heruk on Nov 23, 2014 12:45:08 GMT -6
ok
|
|
|
|
Post by heruk on Nov 23, 2014 11:33:56 GMT -6
My call is part of the manifold Oring is fused to one of the valve seal faces and holding the valve open,,,so no compression Im pretty sure it wasnt. i didnt get all of the o ring out htough so that may be the problem. @alleypoop do you guys recall when the intake side of the cam holder was not tightened enough? i tightened it down without a torque wrench and got it to run. Is it possible that Id have to use more sq ft lbs now that i hand tightened it like my name was Arnold at that incident?? |
|
|
|
Post by heruk on Nov 23, 2014 11:30:12 GMT -6
There is no compression in this last video thats because the spark plug was not in the whole rich... jk so what do you suggest i check for? the whole pushes my finger off |
|
|
|
Post by heruk on Nov 23, 2014 10:09:12 GMT -6
against the head cover
|
|
|
|
Post by heruk on Nov 23, 2014 0:10:51 GMT -6
the plug is wet. I put a squirt of gas in the big hose that connects to the carb too. nothing
Rich it is blue and orange
|
|
|
|
Post by heruk on Nov 22, 2014 23:31:58 GMT -6
I have no one to hold the camera this time. define no spark. no spark or little spark? because it is definitely sparking.
|
|
|
|
Post by heruk on Nov 22, 2014 21:49:21 GMT -6
|
|
|
|
Post by heruk on Nov 22, 2014 21:46:53 GMT -6
the screw? cant see the spark after i upload it to youtube. where else can i upload a video? o you can it is in the upper middle of the video screen
|
|
|
|
Post by heruk on Nov 22, 2014 21:43:39 GMT -6
here's the spark
|
|
|
|
Post by heruk on Nov 22, 2014 20:35:14 GMT -6
lol
|
|
|
|
Post by heruk on Nov 22, 2014 20:34:48 GMT -6
ok ill do it in an hour
|
|
|
|
Post by heruk on Nov 22, 2014 20:01:37 GMT -6
duct taped it, still wont start
has spark and compression. i smell the exhaust coming out like gas is burning but no start
|
|
|
|
Post by heruk on Nov 22, 2014 13:21:13 GMT -6
after deciding to adjust the valves I found that the manifold was not connected to the carburetor properly. tightened that up and adjusted the valves to .004, Put the valve cover back on and Found this...  its the valve cover hose. Will electrical tape due? duct? Cant find any info on it. Can i cut the hose? does it need to be a certain length? |
|
|
|
Post by heruk on Nov 22, 2014 10:46:19 GMT -6
gah cant get it to start
|
|
