Recent Posts  By   (Read times)

Hey guys, the doom of the black scoot begins again! LOL One day I was going up hill and suddenly I felt a snap in my throttle and my throttle bar would turn all the way and I go no gas. Upon later inspection, I found my throttle cable had snapped! How does the heart and soul snap?! Well I went in to do an inspection and found out that the wire was just corroded horrifically. Went to wal mart and got a new wire, basic brake cable! Now it rides nice, and when I give it gas it's nice and smooth. Crazy! Was weird to replace but wasn't too bad to do on my own

The bolt head snapped off. The bottom half is still in the screw spot. What I meant by how it sounded awesome is that it's smooth. Before it was loud and sounded kind of crappy. But all I had to do was get the broken half of the bolt out. Replaced it and there is no oil leaking now. I had to adjust the idle screw. It was set way too high.
Good news though! My scoot is up and running awesome! After putting the cap on correctly and adjusting everything just right it is running like a champ! Just got home from test driving it and also cruising ;D Doesn't bog at all and just goes! When I hit the breaks I don't have to worry about it it shutting off. Starts on the first try now from a cold start. Stays on when cold starting!!!! This scooter is so awesome now!! I took it to the original owner and he said it's running better than when he had it So thanks for ALLLLL of the help guys! You guys here rock!!!!!!!!! Now my next challenge is to paint it Install LED underneath it. Big bore kit it. Yup that's right LOL Just kidding. I love it the way it is now and it's staying this way!!! I can't believe that this scooter is running this good!!!!! It's amazinnggggg
Thanks guys

Valves properly adjusted and scoot starts and sounds pretty awesome. Doesn't sound like crap, sounds very smoooothhhhhh. Now. Next problem lol. I am leaking oil like crazy. I know why though. A while back when tightening the bolt to the intake valve cover I snapped the bolt. Awesome. This was the same day I snapped the adjuster screw ;D Well, the engine starts right up on the first try no problem! It idles crazy high and leaks oil. Why? Well it is leaking from the spot that has no bolt in it. I tightened the other very well expecting it to be enough to hold it, but it wasn't LOL. Oil comes pouring out of there and runs down to my muffler and onto my catcher under the scooter and onto the ground. Scooter is awesome though. All the pressure that the engine has is too much for the one bolt. Which probably explains why it idles so freaking high. I'm talking about 4500 high! If I hit the throttle, to lets say 6000, it will stay there spewing oil like crazy

Any helpful hints on getting that broken screw off? Could I make a slit in it and try using a flat head to get it out? How would I make a slit in that bolt though? Perhaps taking a hammer and hammering the flat head into the bolt?
Thanks for all the help guys! I'm so happy that my scoot still runs from me doing all of this Just have to fix this minor problem and I'll be good to go ;D

Well!!! The part came!!!!! It was by FedEx!! Not UPS nor by noon.. but can't complain too much! It's here!! I put it in my scoot fitted perfectly! I properly adjusted the exhaust earlier today while the engine was is TDC. Both rocker arms were able to move freely Now, the only problem I am having and have been having before is when I tighten the lock nut and everything. I check the measurement, they are good. Started the scoot up. I heard a very faint tick tick tick, then it gradually got louder to a super loud clatter clatter clatter as before. I checked the adjuster screw and it's almost about to fall off. Did it again and same thing. I was having the problem before though. Am I just not tightening that lock nut tight enough? It's pretty tough to tighten it very hard and hold that adjuster in place. When I start to apply slight torque to the lock nut the adjuster screw starts to turn. I have to fight with it to get it to stay in place. Any thing I'm doing wrong or anything that shouldn't be happening? I'm heading to work now. So please leave comments and/or suggestions. Will check during work ;D Thanks for all of the help guys!!! I'm off to work. Seeee yaaaaa

I am. This is ridiculous.

Has anybody ordered from gokartusaonline.com before? I placed my order early Friday morning and chose One day shipping by noon, and I'm expecting it to come today. Yet, on my order invoice I have no order number nor do I have tracking information! I go to my account and hit invoice history and nothing shows up? But the money has been taken out of my account!
Just wondering if anybody ordered from them and this happened to them and they still received their shipment?
Thanks guys!

Thanks. Just ordered the adjuster and nut. Probably isn't necessary to order the nut, but I like new things ;D Hopefully this will fit! I've checked with scooter shops around where I live, auto shops, auto stores, hardware stores and cannot find something that will fit this! I was trying to avoid the really expensive shipping costs..... This stuff is EXPENSIVE.